(as of Jan 28,2021 14:01:14 UTC – Details)
1.Loosen the stop screw.
**Please be careful of spring pop out
2.Pull the wire out and insert into drain. When it reaches clogged area, fasten the stop screw.
**Because of the spring wire can fall into the drain, after loosen the screw, please hold it with a hand when you insert the wire into drain.
3.Please fasten the stop screw when the distance between cleaner and drain is under 20cm(7.8in). If the distance is too far, the spring
cannot receive strength so, the wire can be entangled.
4.Hold the T-handle with one hand and turn the knob on storage clockwise with the other hand. The spring will catch the clogged matter while getting in.
If it can’t get into the pipeline or get to a blockage, then tighten the screw and then press the handle and wire towards the drain while
turning the hand crank clockwise to break up the blockage until the wire getting into the drain smooth and continuously.
5.If the drain cannot be unplugged, please repeat these steps.
6.When you have removed the blockage, please pull the spring out little by little and smoothly.
**If you take out the spring fast or by force, the spring will be damaged so then it cannot be used anymore
7.If the wire cannot be removed, it means there is lots of clogged matter. So, please turn the crank counterclockwise slowly to take out.
8.Please put some rust inhibitor or oil to prevent rust and to keep the product with good condition. Loosen the screw and push the spring into the storage.
**In case of the wire out of the container, it can be assembled along the inlet port as the previous way without unscrewing the screw to open the container
EASY! – it cleans clogged drain easily along the curves of the drain with the durable structure of the long spring. The length of the cleaner is same as professional equipment but cheaper! Good use for clogged piping of all drainage including garden drain, sink, toilet, toilet drain, shower drain, washing machine drain, etc
HYGIENIC STORAGE! – the cleaner can be stored hygienically by wind up the cable in the assembled container.
1. Loosen the stop screw. 2. Put spring into drain until it gets clogged area then fasten the stop screw. 3. Turn knob on storage clockwise. 4. Loosen stop screw and take out the spring wire slowly to remove the clogged matter.
Please read manual we provided or on the below description before use. There are few matters that require attention such as; If the distance between cleaner and drain is too far, the spring wire can be entangled.
Size: 6 x 12.5 inch